Dry Ice Blasting Spray Foam Removal in Barnstaple is the fastest way to strip failed spray foam from lofts, roofs and walls without soaking your building. We use dry ice pellets at -78.5C to freeze and crack the foam, then lift it away with industrial vacuums. If a surveyor or lender has flagged your insulation, we can help.
Dry Ice Blasting Spray Foam Removal in Barnstaple is a non-abrasive process that uses compressed dry ice pellets to freeze spray foam until it turns brittle, then blasts it away from timber, plasterboard and masonry. The pellets sublimate on contact, so there is no water, no chemical residue and no secondary cleanup. We pair the blasting with an industrial vacuum and air scrubber to capture every particle. It is the cleanest method for open cell and closed cell spray foam, especially where the foam has bonded hard to roof timbers.
Most Barnstaple homeowners call us because a mortgage lender has refused to lend on a property with spray foam in the roof, or because trapped moisture has started to rot the timbers. North Devon's damp climate makes that worse. We also get called to loft conversions in Pilton and Roundswell where the foam was installed too thick and is now causing condensation. If you are searching for dry ice spray foam removal near me Barnstaple, we cover the whole town and surrounding villages.
Every job includes a free assessment, full site protection, dry ice blasting, cleanup and a written report. Here is what you get when you book with us.
We visit your property, inspect the spray foam with thermal imaging and moisture meters, and identify any hidden problems. You get a fixed written quote the same day. This assessment is free and there is no obligation to book.
We seal off the work area with polythene sheeting and set up negative air machines to prevent dust spread. Floors are covered and vents are masked. We treat your home like our own and leave it clean.
Our trained technicians use dry ice blasting equipment to remove the foam. We work in sections, using industrial vacuums to capture debris as we go. The process is fast, clean and safe for your building.
After blasting, we check every timber with a moisture meter and thermal camera to confirm no foam residue remains. We also look for signs of rot or damage and advise you on any further action needed.
You receive a full report with before and after photos, moisture readings and a description of the methods used. This is often required by mortgage lenders and surveyors. We can format it to their requirements.
We visit your property, inspect the spray foam with a thermal imaging camera and moisture meter, and identify any timber rot or trapped moisture. You get a written quote the same day, usually within two hours of the visit. We also check whether the foam is open cell or closed cell, as that affects the blasting pressure we use.
On the day of removal, we seal off the work area with polythene sheeting and set up a negative air machine to stop dust spreading through the house. We lay protective floor coverings and mask any vents or electrical fittings. This takes about 45 minutes on a typical loft job.
Our technicians wear full PPE including respirators, coveralls and gloves. We blast the foam with dry ice pellets at -78.5C, working in sections. The foam freezes, cracks and falls away. An industrial vacuum runs alongside to capture debris. A 40 square metre loft takes four to six hours.
Once the foam is gone, we vacuum every surface and run an air scrubber to remove airborne particles. We check the timbers with a moisture meter and take thermal images to confirm no foam residue remains. The area is left clean and ready for new insulation or a surveyor's inspection.
We provide a written report with before and after photos, moisture readings and a description of the methods used. If you need documentation for a lender or surveyor, we can format it to their requirements. We also give you advice on ventilation and next steps for your roof.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
The core of our service. It fires dry ice pellets at high velocity to freeze and crack spray foam without damaging the surface underneath.
Captures foam debris and dust as we blast, keeping the work area clean and preventing particles from spreading through your home.
Filters airborne particles after blasting, ensuring the air is clean before we remove the sheeting and hand back the space.
Creates negative pressure in the work zone so dust and debris cannot escape into other parts of the building.
Detects trapped moisture and missing insulation behind surfaces, helping us identify problems before and after foam removal.
Measures moisture levels in timber and plasterboard. We use it to check for damp and confirm the roof structure is dry after removal.
Protects our technicians from dust and debris. We wear full PPE on every job, no exceptions.
A 1930s semi-detached house in Pilton had spray foam installed across the entire roof slope. The homeowner was told by their mortgage lender that the foam had to be removed before they could remortgage. The foam was trapping moisture and the timbers were showing early signs of rot.
We removed all the foam in one day using dry ice blasting. Moisture readings taken after removal showed the timbers were dry. We provided a report with photos, which the lender accepted. The homeowner completed their remortgage two weeks later.
A warehouse in Roundswell had spray foam insulation that was failing, causing energy inefficiency and high heating costs. The foam was also starting to come away from the roof panels, creating a mess.
We removed the foam from 200 square metres of roof using dry ice blasting over three days. The roof panels were left clean and ready for new insulation. The client reported a 15% reduction in heating costs after installing new insulation.
A bungalow in Sticklepath had spray foam on the underside of the roof tiles. The owner noticed damp patches on the ceiling and was worried about structural damage. A surveyor had flagged the foam as a problem.
We removed the foam with dry ice blasting and found no structural damage. The roof timbers were dry and sound. We provided a report that the owner used to get a clean survey. The damp patches were traced to a blocked gutter, which we also fixed.
Spray foam can cause serious problems if it is installed incorrectly or in the wrong place. Here are the most common issues we fix for Barnstaple homeowners.
Ask a pro →We remove the foam with dry ice blasting and provide a documented report with photos and moisture readings. This is often enough to satisfy lenders and surveyors, allowing your transaction to proceed.
Dry ice blasting removes the foam without adding water, allowing the timbers to dry out. We inspect for rot and can advise on treatment. Removing the foam stops the problem getting worse.
Spray foam can block ventilation. We remove it and check the roof space for airflow. We then advise on ventilation improvements to prevent condensation returning.
We remove the failed foam and prepare the area for new, correctly installed insulation. This restores thermal performance and can lower your heating bills.
Most residential jobs in Barnstaple cost between £1,200 and £3,500 depending on the area of foam and access. A typical 40 square metre loft starts around £1,800. Commercial or complex roofs can run higher. We give you a fixed written quote after a free assessment, so there are no surprises.
Yes. Dry ice blasting is non-abrasive and uses no water or chemicals, so it will not damage timber, plasterboard or masonry. The dry ice pellets sublimate on contact, leaving no residue. We use negative air machines and PPE to protect your home and our team. It is one of the safest methods available.
It is a process that uses compressed dry ice pellets at -78.5C to freeze spray foam until it becomes brittle, then blasts it away from surfaces. The pellets turn back into gas, so there is no water or chemical cleanup. We use it to remove open cell and closed cell foam from lofts, roofs and walls.
A typical 40 square metre loft takes one day, usually four to six hours of blasting plus setup and cleanup. Larger roofs or commercial spaces can take two to three days. We give you a clear timeline in your quote and stick to it. Most jobs are completed within a week of your first call.
Spray Foam Removal near meIf you are searching for spray foam removal near me in Barnstaple, we cover the whole town and surrounding villages. We remove open cell and closed cell foam from lofts, roofs and walls, using dry ice blasting for a clean finish.Explore →
Same day Spray Foam RemovalWhen a surveyor or lender needs foam gone quickly, we offer same day spray foam removal across Barnstaple. Call before 10am and we can often be on site that afternoon. We bring all equipment and leave the area clean.Explore →
24/7 Spray Foam RemovalFor urgent situations, our 24/7 spray foam removal line is open. Whether it is a leak, a last-minute survey or a commercial deadline, we can arrange out-of-hours work. Call 0127 159 4024 any time.Explore →
Residential Spray Foam RemovalMost of our work is residential spray foam removal in Barnstaple. We remove foam from lofts, roofs, walls and floors in houses, bungalows and flats. We protect your home with sheeting and negative air machines, and clean up fully afterwards.Explore →
Commercial Spray Foam RemovalWe handle commercial spray foam removal for warehouses, offices and agricultural buildings across Devon. Dry ice blasting is ideal for large spaces because it is fast and creates no water damage. We work around your schedule to minimise disruption.Explore →
Loft Spray Foam RemovalLoft spray foam removal is our most common job in Barnstaple. We clear foam from roof timbers and rafters, check for rot and trapped moisture, and leave the loft ready for new insulation. A typical loft takes one day.Explore →
Roof Spray Foam RemovalRoof spray foam removal often goes hand in hand with dry ice blasting. We remove foam from the underside of roof tiles and timbers, taking care not to damage the roof structure. We inspect for leaks and rot as we work.Explore →
Attic Spray Foam RemovalAttic spray foam removal in Barnstaple follows the same process as loft removal. We access tight spaces with specialised equipment, blast the foam away and vacuum the area clean. We also check ventilation to prevent future condensation.Explore →Call Union Trust Spray Foam on 0127 159 4024 for a free assessment and same-day written quote. We are CHAS accredited, fully insured and we guarantee our workmanship. If your lender or surveyor has flagged spray foam, we can help you resolve it quickly.
Get a Free Quote 0127 159 4024 →Ring us on 0127 159 4024 or email [email protected] and we will get back to you the same working day. We are open Monday to Friday, 8am to 6pm, with a 24/7 line for emergencies. Free assessments across Barnstaple and North Devon.